Clean up code

nanovna.h

@@ -33,14 +33,18 @@
 #define POINTS_COUNT     290
 #define MARKER_COUNT    4
 
-#define TRACE_COUNT     3
+#define TRACES_MAX 3
+#define TRACE_AGE       3
 #define TRACE_ACTUAL    2
 #define TRACE_STORED    1
 #define TRACE_TEMP      0
+// #define age_t     measured[TRACE_AGE]
 #define stored_t  measured[TRACE_STORED]
 #define actual_t  measured[TRACE_ACTUAL]
 #define temp_t    measured[TRACE_TEMP]
-typedef float measurement_t[3][POINTS_COUNT];
+
+
+typedef float measurement_t[TRACES_MAX][POINTS_COUNT];
 extern measurement_t measured;
 #endif
 
@@ -243,8 +247,6 @@ extern const uint16_t numfont16x22[];
 #define S_OHM   "\036"
 // trace 
 
-#define TRACES_MAX 3
-
 #define MAX_TRACE_TYPE 12
 enum trace_type {
   TRC_LOGMAG=0, TRC_PHASE, TRC_DELAY, TRC_SMITH, TRC_POLAR, TRC_LINEAR, TRC_SWR, TRC_REAL, TRC_IMAG, TRC_R, TRC_X, TRC_OFF
@@ -418,7 +420,7 @@ void show_logo(void);
  * flash.c
  */
 
-#if 0
+#if 1
 #define SAVEAREA_MAX 5
 // Begin addr                   0x08018000
 #define SAVE_CONFIG_AREA_SIZE   0x00008000

si4432.c

@@ -132,7 +132,6 @@ void SI4432_Reset(void)
 {
   int count = 0;
   // always perform a system reset (don't send 0x87)
-again:
   SI4432_Write_Byte( 0x07, 0x80);
   chThdSleepMilliseconds(25);
   // wait for chiprdy bit
@@ -147,7 +146,6 @@ void SI4432_Transmit(int d)
   SI4432_Write_Byte(0x6D, (byte) (0x1C+d));
   if (( SI4432_Read_Byte ( 0x02 ) & 0x03 ) == 2)
     return; // Already in transmit mode
-again:
   chThdSleepMilliseconds(20);
   SI4432_Write_Byte( 0x07, 0x0b);
   chThdSleepMilliseconds(20);
@@ -161,7 +159,6 @@ void SI4432_Receive(void)
   int count = 0;
   if (( SI4432_Read_Byte ( 0x02 ) & 0x03 ) == 1)
     return; // Already in receive mode
-again:
   SI4432_Write_Byte( 0x07, 0x07);
   chThdSleepMilliseconds(10);
   while (count++ < 100 && ( SI4432_Read_Byte ( 0x02 ) & 0x03 ) != 1) {
@@ -188,7 +185,7 @@ static short RBW_choices[] = {     // Each triple is:  ndec, fils, WISH*10
 
 float SI4432_SET_RBW(float w)  {
   uint8_t dwn3=0;
-  uint32_t WISH = (uint32_t)(w * 10.0);
+  int32_t WISH = (uint32_t)(w * 10.0);
   uint8_t ndec, fils, i;
   if (WISH > 6207)   WISH=6207;     // Final value in RBW_choices[]
   if (WISH > 1379) dwn3 = 1 ;
@@ -232,6 +229,7 @@ int actualStepDelay = 1500;
 float SI4432_RSSI(uint32_t i, int s)
 {
   int RSSI_RAW;
+  (void) i;
   // SEE DATASHEET PAGE 61
 #ifdef USE_SI4463
   if (SI4432_Sel == 2) {
@@ -252,7 +250,7 @@ float SI4432_RSSI(uint32_t i, int s)
 }
 
 
-void SI4432_Sub_Init()
+void SI4432_Sub_Init(void)
 {
   SI4432_Reset();
   SI4432_Write_Byte(0x05, 0x0);