From e7d21ccb93682cc099698a3ddf99f587ba02d2d3 Mon Sep 17 00:00:00 2001 From: alanbjohnston Date: Wed, 24 Jul 2019 14:20:59 -0400 Subject: [PATCH] added requirements of git, wiringpi, and libcurl --- README.md | 13 +++++++------ 1 file changed, 7 insertions(+), 6 deletions(-) diff --git a/README.md b/README.md index d9367e2f..dbd30aa7 100644 --- a/README.md +++ b/README.md @@ -2,6 +2,11 @@ The CubeSat Simulator https://github.com/alanbjohnston/CubeSatSim/wiki is a low cost satellite emulator that run on solar panels and batteries, transmits UHF radio telemetry, has a 3D printed frame, and can be extended by additional sensors and modules. This project is sponsored by the not-for-profit [Radio Amateur Satellite Corporation, AMSAT®](https://amsat.org). +Requires: +- wiringpi +- libcurl4-openssl-dev +- git + See the Wiki Software Install page for more details: https://github.com/alanbjohnston/CubeSatSim/wiki/Software-Install. To build and run the software on a Raspberry Pi 3B, 3B+, or Pi Zero W: `git clone http://github.com/alanbjohnston/CubeSatSim.git` @@ -12,15 +17,11 @@ Edit the afsk/main.c file to set your amateur radio callsign, then `make rebuild` -To hear CW telemetry (Morse code), tune your radio or SDR to 435.297 MHz and enter: - -`./radiocw` - -To stop, Ctrl-C. To hear AFSK telemetry (X.25 data), your radio or SDR to 440.389 MHz FM, and you should receive telemetry from the CubeSat Sim: +To hear AFSK telemetry (X.25 data), your radio or SDR to 434.9 MHz FM, and you should receive telemetry from the CubeSat Sim: `./radioafsk` -This code uses the Brandenburg Tech Digital Transceiver, based on DigitalTxRxRP https://brandenburgtech.wordpress.com/ +This code uses the Brandenburg Tech Digital Transceiver, based on DigitalTxRxRP https://brandenburgtech.wordpress.com/ If you don't have the SPI Interface enabled and the board plugged in, you will get an error. This repository contains: